SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
14. Troubleshooting
Factory reset will restore the luminaire to its default state and all the group
configuration settings will be deleted. Reset operation can be used to bring any wrongly
configured luminaire back to its original factory reset condition.
Point remote to any luminaire and press
“unlock,” once.
Wait for LED to stop blinking (apx. 10
seconds).
Point remote to any of the luminaires
and press “send.”
Red LED on remote will start
blinking.
Red LED on remote will stop
blinking.
The luminaire will FLASH twice
and group light level will go to
50%.
Point to any of the luminaires in the
group and press “reset.”
Once LED stops blinking, with remote
still pointing to the luminaire in the
group, press “send.”
Red LED on remote will start
blinking.
Luminaire will turn OFF and then
turn back ON to indicate reset.
Repeat step “b” for all the luminaires that need to be reset.
To Next Page
Loading...
