Philips IRT 9090/01 - Page 18

SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
17
e.
To test the zone, point to any luminaire
and press the “right arrow” key.
Press the right arrow key again to move
to verify the next zone.
All the luminiare in the selected
zone will go to 50% while the
luminaires in the other zone will go
to 5%.
f.
Point to any of the luminaires in the
group and press “lock.”
Wait for LED to stop blinking (apx. 10
seconds) then press “send.”
Red LED on remote will start
blinking.
The luminaire will FLASH twice.
Group is ready for normal
operation.
g.
Alternately zones can also be re-tested
after locking the group.
Point remote to any of the luminaires in
the created zone and press “zone”.
Point to the same luminaire and press
“on” or “off.”
To stop the test process, point to the
same luminaire and press “close.”
The entire zone turns on or off
accordingly.
Rest of the group