Philips IRT 9090/01 - Page 24

SpaceWise for Industrial Applications
v. 1.6
Philips Lighting North America
23
c.
Press the “save” button, the light level is
stored as a new daylight set-point.
Red LED on remote will blink.
The entire group will FLASH twice
and group light level will go to
50%.
d.
Point to any of the luminaires in the
group and press “lock.”
Wait for LED to stop blinking (apx. 10
seconds) then press “send.”
Red LED on remote will start
blinking.
The luminaire will FLASH twice.
Group is ready for normal
operation.