Philips LC7.1E LA - Page 12

Mechanical Instructions
EN 12 LC7.1E LA4.
4.3.5 Mid-range Speakers
1. Remove the rear cover, as described earlier.
2. Refer to fig. "Mid-range speakers" below.
3. Unplug connectors [1].
4. Remove T10 parker screws [2].
Figure 4-12 Mid-range speakers
4.3.6 Tweeters
1. Remove the rear cover, as described earlier.
2. Refer to fig. "Tweeters" below.
3. Unplug connectors [1].
4. Remove T10 parker screws [2].
Figure 4-13 Tweeters
4.3.7 Small Signal Board (SSB)
1. Remove the rear cover, as described earlier.
2. Refer to fig. "SSB removal" below.
3. Disconnect all cables [a] on the SSB.
4. Remove the T10 tapping screws [b] that hold the SSB. See
Figure "SSB removal".
5. Remove the screws that hold the CINCH and HDMI
connectors at the connector panel.
6. Lift the SSB from the set.
Figure 4-14 SSB removal
4.3.8 Main Supply Panel
Some models (37 and 42PFL3312) come with a so-called IPB
(Integrated Power Board) power supply. This power supply
also incorporates the backlight inverters.
1. Refer to next figures.
2. Unplug cables [a].
3. Remove the fixation screws [b].
4. Take the board out (it hinges at the left side).
Figure 4-15 Main supply panel (non IPB PSU)
Figure 4-16 Main supply panel (IPB PSU)
G_16850_010.eps
110107
2 1 2
G_16850_011.eps
110107
2 1
G_16860_074.ep
s
01020
7
a a
b (2x)b (3x)
b (3x)
b (2x)
G_16860_065.ep
s
01020
7
a
a
a
b (3×)
H_16940_016.eps
310707
a
a
a
b (10×)