EasyManua.ls Logo

Philips LX9000R - Page 3

Philips LX9000R
251 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Video - YC (Hosiden)
Input voltage Y :1Vpp ± 3dB
Input impedance Y :75 W
Input voltage C :burst 300 mVpp ± 3 dB
Input impedance C :75 Ohm
Video Performance
All outputs loaded with 75 Ohm
SNR measurements over full bandwidth without weighting.
SCART (RGB)
SNR : > -65 dB on all outputs
Bandwidth : 4.8 MHz ± 2dB
Audio Performance CD
Cinch Output Rear
Output voltage 2 channel mode :1.8Vrms ± 2dB
Channel unbalance (1kHz) :<1dB
Crosstalk 1kHz :<-85dB
Crosstalk 20Hz-20kHz :<-70dB
Frequency response 20Hz- 20kHz :±0.5dB max
Signal to noise ratio :>80 dB
Dynamic range 1kHz :>75dB
Dynamic range 20Hz-20kHz :>70dB
Distortion and noise 1kHz :<-70dB
Distortion and noise 20Hz-20kHz :<-55dB
Intermodulation distortion :<-77dB
Mute :>95dB
Outband attenuation :>40dB above 30kHz
Scart Audio
Output voltage 2 channel mode :1.4Vrms ± 2dB
Channel unbalance (1kHz) :<1dB
Crosstalk 1kHz :<-85dB
Crosstalk 20Hz-20kHz :<-70dB
Frequency response 20Hz- 20kHz :± 0.5dB max
Signal to noise ratio :>80 dB
Dynamic range 1kHz :>75dB
Dynamic range 20Hz-20kHz :>70dB
Distortion and noise 1kHz :<-70dB
Distortion and noise 20Hz-20kHz :<-55dB
Intermodulation distortion :<-70dB
Mute (spin-up, pause, access) :>85dB
Outband attenuation :>40dB above 25kHz
Digital Output
Coaxial
CDDA/ LPCM (incl MPEG1) :according IEC958
MPEG2, AC3 audio :according IEC1937
DTS :according IEC1937, amendment 1
Digital Video Input (IEEE 1394)
Applicable Standards
Implementation according:
IEEE Std 1394-1995
IEC 61883 - Part 1
IEC 61883 - Part 2 SD-DVCR (02-01-1997)
Specification of consumer use digital VCR’s using 6.3 mm magnetic
tape - dec.1994
Mechanical connection according: Annex A of 61883-1
P50 System Control
Via SCART pin nr 10
Power Amplifier
Power stage protection :temperature and short circuit
Output power
Stereo mode (1kHz, 10% distortion) :2x 70W rms
Surround mode (1kHz, 10% distortion)
Front :2x 80W rms
Centre :80W rms
Surround :2x 80W rms
Sub Woofer :80W rms
Headphone
3.5mm stereo jack, 8 - 600 Ohm
2.8V EMF
Dimensions and Weight
Height of feet :10mm
Apparatus tray closed :WxDxH :435 x 405 x 96mm
Weight without packaging :appr. 9 kg (main set)
appr. 19.7kg (speaker boxes)
Weight in packaging :appr. 28.7 kg
Laser Output Power & Wavelength
DVD
Output power during reading :0.8mW
Output power during writing :20mW
Wavelength :660nm
CD
Output power :0.3mW
Wavelength :780nm
EN 31.LX9000RTechnical specification

Other manuals for Philips LX9000R

Related product manuals