Philips M2805 - Display DAB+ Information; 7 Listen to FM Radio; Tune to FM Radio Stations; Store FM Radio Stations

11
EN
[Station order]: Enable you to dene how the stations
are arranged when scrolling the station list.
[System settings]: Adjust system settings.
[Main Menu]: Access main menu (See the Chapter
“Use main menu”).
3 To select an option, press [SELECT] or [OK].
4 If a sub-option is available, repeat steps 2-3.
• To exit the menu, press [MENU] /
[INFO] again.
[Prune invalid]
» [Ye s]: Remove all the invalid stations from
the station list.
» [No]: Return to the previous menu.
[DRC]
» [DRC high]: Switch DRC on to a high level
(the default option recommended for noisy
environments).
» [DRC low]: Switch DRC on to a low level.
» [DRC off]: Switch DRC off.
[Station order]
» [Alphanumeric]: Arrange the stations in
alphabetical order (default setting).
» [Ensemble]: List groups of stations that are
broadcast together on the same ensemble (I.e.:
BBC or South Wales local).
Note
• If no button is pressed within 15 seconds, the menu will exit.
Display DAB+ information
While listening to DAB radio, press [MENU]
/ [INFO] repeatedly to display various
information (if available).
• Station name
• Dynamic Label Segment (DLS)
• Signal Strength
• Program type (PTY)
• Ensemble Name
• frequency
• Signal error rate
• Bit rate and audio status
• Codec
• Time and date
7 Listen to FM
radio
Tune to FM radio stations
1 In the main menu, select [FM] mode.
2 Press and hold ( or ) for more than
2 seconds.
» The radio tunes to an FM radio station
with strong reception automatically.
3 Repeat Step 2 to tune to more stations.
» To tune to a weak station: Press and
hold ( or ) repeatedly until you
nd an optimal reception.
Store FM radio stations
Note
• You can store a maximum of 20 FM radio stations.
1 In FM mode, tune to an FM station.
2 Press and hold [PRESET] for 2 seconds
until [Save to Preset] is displayed.
3 Press the navigation buttons to allocate a
number from 1–20 to this radio station,
then press [SELECT] to conrm.
» [Preset stored] is displayed.
4 Repeat steps 1-3 to program more stations.
Note
• To overwrite a programmed station, store another station
in its place.