English
33
Manual programming
1 Tune to your desired station (see “Tuning to
radio stations”).
2 Press PROGRAM to activate programming.
3 Press í / ë on the remote to allocate a
number from 1 to 40 to this station.
4 Press PROGRAM again to confirm the setting.
➜ The preset number and the frequency of the
preset station are shown.
5 Repeat the above four steps to store other
stations.
● You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
● Press í / ë until the desired preset station is
displayed.
Changing tuning grid (not available for
all versions)
In North and South America, the frequency step
between adjacent channels in the MW band is
10 kHz (9 kHz in some areas). The preset
frequency step in the factory is 10 kHz.
Changing the tuning grid will erase all
previously stored preset radio stations.
Press and hold 9 on the system in the tuner
mode.
➜ The display will show "9 GRID" or
"10 GRID".
Notes:
– GRID 9 and GRID 10 indicate that the tuning
grid is in step of 9 kHz and 10 kHz respectively.
Radio Reception
pg021-pg044_MCD299-98-Eng-B 2007.9.27, 13:0533
To Next Page
Loading...
