Philips MCM760 - Dismantling of the Cover Cassette and Universal Loader; Detaching the Universal Loader from the Bracket Module Mounting; Detaching the Front Panel Assembly from the Bottom;Rear Assembly

2-1
2-1
DISMANTLING INSTRUCTIONS
Dismantling of the Cover Cassette and Universal Loader
1) Remove the Cover Cassette (pos 1+pos 2) in the direction as
shown in Figure 1.
2) Loosen 4 screws to remove the Cover Top (pos 62) by
sliding it out towards the rear before lifting up.
- 2 screws on the rear
- 1 screw each on the left & right side
3) Loosen 2 screws each to remove the Panel Left (pos 61)
and Panel Right (pos 60). The Panels are removed by
sliding it towards the rear and outwards.
- 1 screw on the rear
- 1 screw on the side
- see Service position A
4) Loosen 4 screws A (see Figure 2) to remove the Bracket
Module Mounting (pos 54) and Universal Loader (pos
58).
- 2 screws each on the left & right side
Detaching the Universal Loader from the Bracket Module Mounting
Figure 1
Figure 3
Figure 5
7erugiF
1) Remove 2 screws C (see Figure 5) from the bottom of the
Cabinet Front .
Detaching the Front Panel assembly from the Bottom/Rear assembly
2) Release the fixation of the Main Board to BracketCombi
by removing the 1 screw and pulling the Main Board
outwards (see Figure 6).
3) Uncatch 2 catches on the left & right sides of the Cabinet
Front and slides the Front Panel assembly out towards
the front.
- see Service position C
Figure 4
1) Slide outthe Loader Tray fully and remove4 screws B(see
Figure 4) to detach the Universal Loader (pos 58) from
the Bracket Module Mounting (pos 54).
- see Service position B
Figure 2
5) Shake up the Bracket Module Mounting and CD Loader
as shown in Figure 3 till the Cover CD (pos7) fall off.