13
Note
Before pressing any function button on the remote
control, fi rst select the correct source with the remote
control instead of the main unit.
If you are not going to use the remote control for a
long time, remove the battery.
•
•
Set clock
1
In the standby mode, press and hold
CLOCK to activate the clock setting
mode.
The hour digits are displayed and begin
to blink.
If the hour digits are not displayed,
press and hold
for more than 2
seconds to switch to standby mode,
then repeat step 1.
2 Press + VOL - to set the hour.
The minute digits are displayed and
begin to blink.
3 Press + VOL - to set the minute.
4 Press CLOCK to confi rm the clock setting.
Turn on
1
Press .
The audio system takes 10 seconds to
heat up before it turns on.
The audio system switches to the last
selected source.
Switch to standby mode
1 Press to switch the audio system to Eco
Power Standby mode.
The backlight on the display panel
turns off.
The blue Eco Power indicator turns on.
»
»
»
»
»
»
»
Connect power
Caution
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back
or the underside of the audio system.
Risk of electric shock! When you unplug the AC power
cord, always pull the plug from the socket. Never pull
the cord.
Before connecting the AC power cord, ensure you have
completed all other connections.
•
•
•
1 Connect the power cord to the wall outlet.
Prepare the remote control
Caution
Risk of explosion! Keep batteries away from heat,
sunshine or fi re. Never discard batteries in fi re.
•
1 Open the battery compartment.
2 Insert 2 AAA batteries with correct
polarity (+/-) as indicated.
3 Close the battery compartment.
English
EN
Book_1.indd Sec1:13Book_1.indd Sec1:13 2008-07-29 17:28:062008-07-29 17:28:06
To Next Page
Loading...
