1
PL House Light MKII LED Luminaires
User’s Manual
IMPORTANT INFORMATION
Warnings and Notices
When using electrical equipment, basic safety precautions should always be followed including the following:
a. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
b. Do not use outdoors. Only suitable for indoor use.
c. Do not mount near gas or electric heaters.
d. Equipment should be mounted in locations and at heights where it will not readily be subjected to
tampering by unauthorized personnel.
e. The use of accessory equipment not recommended by the manufacturer may cause an unsafe
condition.
f. Do not use this equipment for other than intended use.
g. Refer service to qualified personnel.
h. This luminaire is specified to operate in an ambient temperature of 40
o
C. The luminaire’s exterior
surface temperatures:
• After 5 minutes of operation: 42
o
C
• When steady state is achieved: 47
o
C
SAVE THESE INSTRUCTIONS.
WARNING: You must have access to a main circuit breaker or other power disconnect device before installing
any wiring. Be sure that power is disconnected by removing fuses or turning the main circuit breaker off before
installation. Installing the device with power on may expose you to dangerous voltages and damage the device.
A qualified electrician must perform this installation.
WARNING: Refer to National Electrical Code® and local codes for cable specifications. Failure to use proper
cable can result in damage to equipment or danger to personnel.
WARNING: This equipment is intended for installation in accordance with the National Electric Code® and
local regulations. It is also intended for installation in indoor applications only. Before any electrical work is
performed, disconnect power at the circuit breaker or remove the fuse to avoid shock or damage to the control.
It is recommended that a qualified electrician perform this installation.
WARNING: The PL House Light MKII LED Luminaire is a NON-IC Rated Lighting Fixture and IS NOT for
residential installation or use.
If the space that a light fixture is to be installed does not contain insulation, a NON-IC rated fixture should
be used (NON-IC stands for NON Insulated Contact). If insulation is present in an application where a
NON-IC rated fixture is used, a minimum 6-inch (153 mm) clearance should exist on all sides of the fixture,
and no insulation may be present across the top of the installed fixture. By maintaining these clearance
requirements, overheating should not be an issue according to testing conducted on the fixture.
WARNING: Basic insulation has been maintained between low-voltage supply and control conductors.
IMPORTANT!
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
CE PRODUIT DOIT ÊTRE INSTALLÉ SELON LE CODE D'INSTALLATION PERTINENT, PAR
UNE PERSONNE QUI CONNAÎT BIEN LE PRODUIT ET SON FONCTIONNEMENT AINSI QUE
LES RISQUES INHÉRENTS.
To Next Page
Loading...
