User’s Manual PL House Light MKII LED Luminaires
8 INSTALLATION AND SET UP
Note: For more information on DMX512 networking and systems, refer to "Additional Resources for DMX512" on
page 2. For PL House Light MKII LED Luminaire DMX Mapping, refer to "DMX CONTROL" on page 19.
Figure 4: PL House Light LED Luminaires - DMX512 Connections
4. Mounting and Connecting Power
Note: The PL House Light MKII LED Luminaire is intended for installation in accordance with the National
Electric Code and local regulations. To assure full compliance with local codes and regulations, check with your local
electrical inspector before installation. The PL House Light MKII LED Luminaire is not intended for residential use
or installation.
WARNING! To prevent injury or death, you must have access to a main circuit breaker or other power disconnect
device before installing any wiring. Be sure that power is disconnected by removing fuses or turning the main circuit
breaker off before installation. Installing the device with power on may expose you to dangerous voltages and
damage the device. A qualified electrician must perform this installation.
DMX512
DMX512
(out from first to second luminaire)
DMX512 (out to the next luminaire
or DMX512 controlled device)
PL House Light LED Luminaires
DMX512 Connections
Note: Remaining pins on each connector are not used.
DMX512 Signal XLR Pin RJ45 Pin
Common (Drain) 1 7
DMX512 - 2 2
DMX512 + 3 1
(from console or
DMX Cables (DMX to RJ45)
DMX512 Cable Options
To Luminaire (RJ45) DMX512 (XLR) Female
To Luminaire (RJ45) DMX512 (XLR) Male
Sold Separately
Note: For cables required to operate and control
PL House Light MKII LED Luminaires via
DMX512, see "Additional Mounting
control device)
To Next Page
Loading...
