Philips SPF4608 - Getting Started with Your PhotoFrame; Installing the PhotoFrame Stand; Connecting the Power Supply; Turning On the PhotoFrame

7EN
3 Get started
Caution
•
Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in
sequence.
If you contact Philips, you will be asked for the
model and serial number of this apparatus. The
model number and serial number are on the
back of the apparatus. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Install the stand
1
PlacethePhotoFrameonaatsurface.
2 Insert the supplied stand to the stand hole
of the PhotoFrame.
Connect power
Note
•
When you position the PhotoFrame, make sure that
the power plug and outlet are easily accessible.
Connect the supplied power adaptor to:
• the DC IN socket of the PhotoFrame
• the AC outlet
» A few seconds later, the PhotoFrame
turns on automatically.
Turn on the PhotoFrame
Note
•
When you connect the PhotoFrame to a power supply,
the PhotoFrame turns on automatically.
When the PhotoFrame is turned off and
connected to the power supply, press and hold
to turn on the PhotoFrame.