Philips SRP4004 - Improving Key Functionality

8 EN
2.3.2 Improvingkeys
Whencorrectlysetup,theremotecontrol
shouldbeabletooperateallyourdevices.
However,whenusingtheremotecontrolforthe
firsttimeitmightoccurthatsomekeysdonot
yetfunctionasexpected.Inthiscaseyoucan
havetheremotecontrolsearchforalternatives.
Note
Improvingkeysisnotpossiblewhenthecode
wasfoundduringfulldatabasesearch(with
code‘9,9,9,9’).
Duringinitialsetup
1 Makesurethereceivingdeviceisableto
respond.E.g.whenyoutrytorepairthePlay
keyforyourDVDplayer,makesuretoinsert
aDVDintotheDVDplayerotherwisethe
Playkeyisnotabletofunction.
2 Pressthekeythatdoesnotfunction,keepit
pressedandimmediatelyreleaseitwhenthe
deviceresponds.Repeatthisforeverykey
thatdoesnotfunction.
• Ifthekeystilldoesnotfunctionasexpected,
trypressingitagainforalongerperiodof
time.
Afterinitialsetup
1 Makesurethereceivingdeviceisableto
respond.
E.g.whenyoutrytorepairthePlaykeyfor
yourDVDplayer,makesuretoinsertaDVD
intotheDVDplayerotherwisethePlaykey
isnotabletofunction.
2 Selectthedevice
thatyouwishto
operate
(e.g.DVD).

 
Pressthe device
selectionkeyto
selectDVD.
3 Keepkeys
 and 
pressed
simultaneouslyfor
5seconds.
 • TheredSetup
light
lights
up.Theremotecontrolisnowinsetup
mode.
4  Pressandholdthekeythatdoesnot
functionandimmediatelyreleaseitwhen
thedeviceresponds.
• Ifthekeystilldoesnotfunctionasexpected,
trypressingitagainforalongerperiodof
time.
5 Pressthe 
deviceselectionkey
twicetosaveyour
settingsandexit
setupmode.
 •
 Whennokey
ispressedfor5minutesormore,the
remotecontrolwillexitsetupmode,
automaticallysavingallyoursettings.
3Usingtheuniversal
remotecontrol
3.1 Keysandfunctions
Theillustrationonpage2givesanoverviewof
allkeysontheremotecontrol.Tryoutthekeys
youneedforoperatingyourdevices.
Notes
• Keyshavingthesamefunctionsasthe
keysonyouroriginalremotecontrolmay
havedifferentnamingsontheSRP4004
(e.g.Info/Display).
• Onlyfunctionsthatareavailableonyour
originalremotecontrolcanbeusedfor
operatingyourdeviceswiththeSRP4004.
1 .................................... Setuplight.Lightsupred
whentheremotecontrol
isinsetupmode.
2 ...............................selectsavailablesource
inputs(antenna,cable,
etc.).
3 ......... deviceselectionkeys.
•selectthedevicetobe
operated.
  •lightupwhenaremote
controlcommandis
beingsent.
5sec.
SRP4004_27__Manual_80_210.indd 8 25-09-09 13:19