30 EN
Display settings
Brightness
or turns off when NP3300 is turned on or
switched to active standby.
In [Settings] > [Display settings] >
[Brightness when on] or[Brightness when
standby]OK.
Backlight timer
action is taken on NP3300. After the pre-
a low value for the time duration.
To set the time duration
In [Display settings] > [Backlight
timer]
»
the idle screen is switched off
automatically.
To exit the power-saving mode
Press any key.
Wallpaper
background display (wallpaper).
To set wallpaper
1
2 Press SETTINGS on the remote control
to select [Settings] > [Display settings] >
[Wallpaper].
3 In [Wallpaper][Current picture].
» Current picture is set as wallpaper.
Screensaver
NP3300 is switched to active standby.
appears. The clock is shown on the lower right
corner of the screen.
screensaver.
To set screensaver
1
2 Press SETTINGS on the remote control
to select [Settings] > [Display settings] >
[Screen saver].
3 In [Screen saver][Current picture].
» Current picture is set as screensaver.
Slideshow settings
pictures one by one.
To select a play mode for slideshow
1 [Settings] >
[Slideshow settings].
SETTINGS on the remote
control to enter [Settings].
2 Select one of the following play modes.
Press OK to turn it on or off.
» [Repeat]: Play all pictures repeatedly;
» : Play all pictures randomly.
To set the play time of each picture
1 [Settings] >
[Slideshow settings] > [Time per slide].
SETTINGS on the remote
control to enter [Settings].
2 In [Time per slide]
duration.
To Next Page
Loading...
