65BDL3652T/75BDL3652T/86BDL3652T
57
Auto Adjust
Press “Set” to detect and adjust H position, V position, Clock,
Phase automatically.
NOTE: This item applies to VGA input only.
Screen reset
Reset all settings in the Screen menu to factory preset values.
9.2.3. Audio menu
Picture
Screen
Audio
Con�guration
Advanced
Android Settings
50
50
50
20
20
100
0
On
Analog
Action
Off
On
Balance
Treble
Bass
Volume
Audio out (line out)
Maximum volume
Minimum volume
Mute
Audio source
Audio reset
Audio Out Sync
Speaker Settings
Balance
Adjust to emphasize left or right audio output balance.
Treble
Adjust to increase or decrease higher-pitched sounds.
Bass
Adjust to increase or decrease lower-pitched sounds.
Volume
Adjust the volume.
Audio out (Line out)
Adjust to increase or decrease line out output level.
Maximum volume
Adjust your own limitation for the maximum volume setting.
This stops the volume at the sound level you set.
Minimum volume
Adjust your own limitation for the minimum volume setting.
Mute
Turn the mute function on/o.
Audio source
Select the audio input source. Audio output is not supported
when there is no video signal.
• {Analog} - Audio from audio input. (Audio from OPS
audio input when OPS is selected as source)
• {Digital} - Audio from video input source. (VGA and DVI
are not supported)
Audio reset
Reset all settings in the Audio menu to factory preset values
for current source.
Audio Out Sync
Line out volume sync with Volume.
• {On} - Enable the function.
• {O} - Disable the function and Audio Out Volume will be
grayed out.
Speaker Setting
Enable/disable speaker.
NOTE: This function is available only when “Audio Out
Sync” is on.
9.2.4. Configuration menu
Picture
Screen
Audio
Con�guration
Advanced
Android Settings
Switch on state
Panel saving
RS232 routing
Boot on source
Logo
WOL
Light sensor
Human sensor
DP version
HDMI version
System rotation
Information OSD
Monitor ID
Force on
Action
RS232
Action
On
Off
Off
Off
1.1
0°
10
Action
Switch on state
Select the display status that will be applied when you
connect the power cord next time.
• {Power o} - The display will remain o when the power
cord is connected to a wall outlet.
• {Forced on} - The display will turn on when the power
cord is connected to a wall outlet.
• {Last status} - The display will return to the previous
power status (on/off mode/standby mode) when
removing and replacing the power cord.
Panel saving
Choose to enable the panel saving functions and thus reduce
the risk of image persistence or ghost imaging.
• {Brightness} - Select {On} and the image brightness will
be reduced to 30%.
• {Pixel shift} - Select the time interval ({Auto} / {10
~
900}
seconds ) for the display to slightly expand the image
size and shift the position of pixels in four directions (up,
down, left, or right). Activating Pixel Shift will disable H
Position, V Position and Zoom Mode in the screen menu.
NOTES:
• Auto is 60 seconds.
• Only supports external input source (HDMI, VGA, DP, OPS,
DVI)
RS232 routing
Select the network control port.
Choose from: {RS232} / {LAN->RS232} / {OPS RS232 (OPS
model only)}.
Boot on source
Choose to select source when booting up.
Last Input : keep last input when booting up.
Input: select input source when booting up.
Playlist: select playlist index for Media player, Browser.
0: No playlist. Same as switching source from OSD.
1
~
7: playlist number.
To Next Page
Loading...
