Philips TAP4805 - User Manual

Questions and Answers

S
Sara BaileyAug 27, 2025
Why is auto-lock not working on my Philips Door locks?
- A
  Alyssa BradshawAug 27, 2025
  If the Auto-Lock feature isn't working on your Philips Door locks, and the battery indicator is flashing continuously, replace the batteries with 4 new AA alkaline batteries. Also, ensure that you have activated the Auto-Lock function.
A
Austin GriffinAug 27, 2025
Why am I receiving low battery alerts on my Philips Door locks?
- T
  Travis RobertsAug 27, 2025
  If you are receiving low battery alerts on your Philips Door locks, remove the current batteries and insert 4 new AA alkaline batteries.
S
Shane Bennett MDAug 28, 2025
What to do if Latch Bolt makes sounds but does not work on Philips Door locks?
- R
  Rebecca HodgesAug 28, 2025
  If, after installation, the Latch Bolt on your Philips Door locks makes sounds but does not work, ensure you have followed the installation instructions, re-install and reset the lock, making sure the Latch Bolt is fully retracted before installing the Exterior and Interior Assembly, not inserting the key during installation, correctly inserting the cable connector of the Exterior Assembly to the socket on the Interior Assembly, keeping the Exterior and Interior Assembly aligned and parallel to the door edge, and the Latch Bolt parallel to the door edge. Restore the lock to the factory default setting and use new 4 AA dry batteries.
D
Dave LewisAug 28, 2025
What to do if I failed to set up my Philips Door locks?
- F
  frankjenniferAug 29, 2025
  If you failed to set up the lock of your Philips Door locks, ensure the lock is installed correctly, insert fresh batteries, and make sure the cable is not pinched. After installation, reset the lock to factory settings to complete the lock setting process.
M
Michelle KelleyAug 29, 2025
Why is there no picture on my Philips Monitor?
- S
  sanchezbrittanyAug 29, 2025
  There are several reasons why your Philips Monitor might not be displaying a picture: 1. The power cord might be disconnected; plug it in. 2. The main power switch on the back of the display might not be switched on; ensure it is on. 3. The selected input might have no connection; connect a signal to the display. 4. The display might be in standby mode.
P
Paula MorrisonAug 30, 2025
Why is no coffee brewed or coffee is brewed slowly in my Philips Coffee Maker?
- J
  Jack FullerAug 30, 2025
  If no coffee is brewed, it's brewed slowly, or it comes out drop by drop from your Philips Coffee Maker, several factors could be at play. The coffee grind might be too fine, or the circuit may not be primed. The brew group or dispensing spout could be dirty, or limescale might be clogging the machine circuit. To address this, you can change the coffee blend or adjust the grinding. Clean the dispensing spout and its holes. Descale the machine.
R
Rachel WrightAug 30, 2025
What to do if my Philips Coffee Maker dispenses no hot water or steam?
- M
  Matthew WilsonAug 30, 2025
  If no hot water or steam is dispensed from your Philips Coffee Maker, the hole of the steam/hot water wand may be clogged. Clean the hole of the steam wand using a pin. Descale the machine.
C
Christina DavisAug 31, 2025
How to make coffee hotter in my Philips Coffee Maker?
- M
  michelle54Aug 31, 2025
  If the coffee from your Philips Coffee Maker is not hot enough, preheat the cups with hot water. Also, ensure the temperature setting is correctly adjusted.
Y
Yesenia NorrisAug 25, 2025
What to do if Philips Door locks only locks but does not unlock?
- J
  Justin SandersAug 25, 2025
  If your Philips Door locks only locks but does not unlock, or the Latch Bolt goes in and out uncontrollably, it might be due to a problem with the door frame. Ensure the hole in the door frame is drilled a minimum of 1"(25mm) deep to provide enough space for the deadbolt. It can also be because of the lock handing or installation. Restore the lock to the factory default setting. If that doesn't work, re-install the lock and reset it again. If the issue persists, further assistance may be needed.
C
Cameron BurkeSep 1, 2025
What to do if the descaling cycle cannot be completed on my Philips Coffee Maker?
- M
  melaniehernandezSep 1, 2025
  If the descaling cycle cannot be completed on your Philips Coffee Maker because not enough water is dispensed for the rinse cycle, press the on/off button and follow the instructions.

This document is a user manual for the Philips TAP4805 Portable DVD Player, part of the 4000 Series of Portable DVD Players.

Function Description

The Philips TAP4805 is a portable DVD player designed to play digital video discs conforming to the universal DVD Video standard. It offers true cinema picture quality and stereo or multi-channel sound, depending on the disc and playback setup. Users can select sound tracks, subtitle languages, and different angles of view. The player also allows for parental control to restrict the playback of discs unsuitable for children. In addition to DVDs, it supports various disc formats and media types, including USB storage devices and SD/MMC cards. The device comes with a main unit and a separate monitor, allowing for dual-screen viewing, particularly useful in a car setting with the included headrest mounts.

Important Technical Specifications

Playable Media:

DVD, DVD-Video, VCD, SVCD, Audio CD
DVD+R/+RW, DVD-R/-RW, DVD+R/-R DL (Dual Layer)
CD-R/-RW (maximum 64 folders and 999 files)
USB storage device

Supported File Formats:

Video: .avi
Audio: .mp3, .wma
Picture: .jpg, .jpeg

USB:

Compatibility: Hi-Speed USB (2.0)
Class support: USB Mass Storage Class
File system: FAT16, FAT32
Maximum number of albums/folders: 64
Maximum number of tracks/titles: 999
USB port: 5V ===, 400mA
Supports USB HDD (Hard Disc Drive); an external power source may be needed.

Video:

Signal system: PAL, NTSC, AUTO
Composite video output: 1 Vp-p (75 ohm)

Audio:

2-channel analog output
Audio Front L&R: 2 Vrms (47k Ohm)

Main Unit:

Dimensions (W x H x D): 248 x 168 x 40 mm
Net Weight: 0.66 kg

Monitor:

Dimensions (W x H x D): 248 x 172 x 35 mm
Net Weight: 0.35 kg

Power:

Power supply rating Input: 100-240V~, 50/60Hz
Power supply rating Output: DC 12V, 2.0A
Power consumption: < 13 W
Power consumption in standby mode: < 0.5W

Laser Specification:

Type: Semiconductor laser InGaAIP (DVD), AlGaAs (CD)
Wave length: 650 nm (DVD), 790 nm (CD)
Output Power: 7.0 mW (DVD), 10.0 mW (VCD/CD)
Beam divergence: 60 degrees

Region Code:

This player can play discs with region code 2 (EU).

Usage Features

Battery and Power:

The device features a rechargeable battery. Charging is done via a supplied AC adaptor or car charger. A red indicator light signifies charging, turning yellow when fully charged (approximately 3.5 hours for a full charge).
The main unit has a DC IN 12V socket for power supply and a DC OUT jack to power the monitor.

Connectivity:

Main Unit: Includes a headphone jack, AV OUT for connecting to the monitor or an external display, SD/MMC slot, USB port, DC OUT, and DC IN.
Monitor: Features DC IN (from main unit), AV IN (from main unit), and a headphone jack.
The main unit and monitor are connected using a supplied AV cable for video/audio signal and a DC power cable.

Controls:

Main Unit: LED display, speakers, OPEN button for disc compartment, play/pause (►), stop (■), MENU, VOL- (reduce volume), VOL+ (increase volume), OFF & ON switch.
Monitor: LED display, speakers, VOL- (reduce volume), VOL+ (increase volume), MENU (short press for settings, long press to turn off), scroll down (▼, also mutes sound), scroll up (▲, also turns off display info), DC IN, AV IN, headphone jack, OFF & ON switch.
Remote Control: Comprehensive controls including power (ن), SOURCE (switch input mode), A-B (repeat section), skip previous/fast rewind (4/◄◄), skip next/fast forward (►►/►), SETUP, scroll up (▲), scroll left (◄, also reduce volume), scroll down (▼), stop (■), number keys (0-9), GOTO (skip to title/chapter/track), MUTE, DISPLAY (screen info), SUBTITLE, REPEAT, AUDIO, MENU (main menu), ENTER (confirm), scroll right (►, also increase volume), play/pause (►), PROG (programming menu).

Playback Features:

Disc Playback: Supports various DVD and CD formats.
USB/SD/MMC Playback: Allows playing media from USB storage devices and SD/MMC cards.
Photo Playback: During a photo slideshow, the remote control can be used to access photo preview, flip photos, rotate photos, and play photos sequentially.
Repeat Play: Options to repeat the current title, chapter, track, or the entire disc/USB contents. Can be cancelled by holding REPEAT until [Off] is displayed.
Skip Play: Allows skipping to a specific title, chapter, track, or time using the GOTO function and number keys.
Auto Play: If enabled, the player will automatically play disc contents after reading.

Settings:

System Setup: TV System, POWER RESUME (resume playback after power-off), AUTO PLAY, TV type, Password, Rating, Default (reset to factory defaults).
Language Setup: OSD Language, Audio Lang, Subtitle Lang, Menu Lang.
Audio Setup: Key (lifting/falling adjustment), EQ (equalizer for different music styles: STANDARD, CLASSIC, ROCK, JAZZ, POP).
Video Setup: Adjust Brightness, Contrast, Hue, Saturation, and Sharpness.
Digital Setup: Dual mono (Stereo, Mono L, Mono R, Mix Mono).
Auto Standby: Enables/disables automatic standby after 15 minutes of inactivity.
Monitor Settings (accessed via monitor's MENU button): PICTURE (Brightness, Contrast, Color, English subtitle language), VOLUME, OPTION (RESET to factory default), SYSTEM (S-ROLOC, AUTO, video type PAL/AUTO/NTSC), CLOCK (sleep and wake times).

Car Usage:

Includes headrest mount straps (2pcs) for attaching the main unit and monitor to car seat headrests.
The remote control can be used by pointing it towards the remote sensor of the main unit.

Maintenance Features

General Care:

Do not insert objects other than discs into the disc compartment.
Avoid inserting warped or cracked discs.
Remove discs if not using the product for an extended period.
Clean the product only with a microfiber cloth.

Software Update:

Users can download software updates from the Philips website.
The software file (named 8202KD.BIN) should be copied to a USB drive.
Insert the USB drive into the player (with no disc inside) to automatically upgrade the software.
It is crucial not to interrupt the power supply during a software update, as this can render the machine unusable.

Battery Maintenance:

Keep batteries away from heat, sunshine, or fire.
Do not mix different brands or types of batteries.
Remove batteries from the remote control if it will not be used for long periods.
Dispose of batteries properly to protect the environment.
Coin-type batteries (if present in product/remote) should be kept out of reach of children.

Safety Precautions:

Hearing Safety: Listen at moderate volumes, avoid adjusting volume as hearing adapts, and do not use headphones in hazardous situations (e.g., while driving). Prolonged exposure to sound, even at safe levels, can cause hearing loss.
Electric Shock Risk: Never remove the casing, expose to rain/water, or place liquid containers near the product. Disconnect immediately if liquids spill. Do not place near naked flames or heat sources. Do not insert objects into ventilation slots.
Short Circuit/Fire Risk: Ensure power voltage matches product specifications. Avoid pressure on power plugs.
Injury/Damage Risk: Do not disassemble to avoid laser radiation exposure. Do not touch the optical lens. Do not place objects on power cords. Allow product to reach room temperature if transported below 5°C before connecting.
Overheating Risk: Do not install in confined spaces. Ensure at least 10 cm ventilation space. Do not cover ventilation slots. Do not use in tropical climates.
Contamination Risk: Do not mix batteries. Replace batteries with the same or equivalent type. Dispose of batteries properly.

Troubleshooting:

The manual provides guidance for common issues such as no picture, no sound, disc not readable, and USB storage device issues. Users are advised to check connections and settings before seeking service.
For support, users can register their product at www.philips.com/support and will be asked for the model and serial number (located on the bottom of the player).