44 EN
Devices conditions
Dynamic
Microphone
Parameters Application areas: stage
performances, karaoke
performances, outdoor campaign;
Technical Parameters:
Single: moving coil
Directional: heart-shaped
Frequency response: 40HZ-
16KHZ
Sensitivity: -50db ± 3db,
(suggested sensitivity is -52db ±
3db, -53db ± 3db, -54db ± 3db,
-55db ± 3db) (0db = 1V / Pa at
1KHZ) dynamic microphone)
Output Impedance: 600Ω ± 30%
(at 1KHZ)
Voltage XLR (0 V)
Cable plug 6.35mm microphone audio
cable to female XLR cable
Reminder Before recording, please transfer
voltage to 0 V, otherwise there
will be noise.
In the professional music field where XLR accessories are
needed, an external integrated 24V/48V XLR phantom power
and phone interface are equipped. The schematic diagram is
as below:
How to use XLR accessories:
when using XLR accessories to record, please connect
accessories connector to XLR,
the device will prompt: "Please turn on the XLR
power",
Please check whether the XLR power is on or not.
During recording, if the XLR accessory connector is
unplugged,
the recording file will be auto-saved;
if the XLR accessory is low power,
the recording file will be auto-saved, and the device
will prompt: "XLR low power, has stopped working"
Please recharge the XLR accessory.
•
•
•
the charging indicator will turn to red. About 2 hours are
needed to fully charge the XLR, and when the charging is
done,
the charging indicator will turn to yellow.
To Next Page
Loading...
