Philips VoiceTracer DVT1120 User Manual

25
Settings
Table of contents
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
8.1.3 Setting microphone sensitivity
You can customize the microphone settings to suit the recording
conditions. Adjust the recording sensitivity to avoid recording
background noises and to adapt to the recording environment.
1
In stop mode (start-up screen), press MENU for at least two
seconds.
2
Press e to select the SENS function.
3
Press h / b to select the required recording quality.
X The selected microphone/recording sensitivity symbol is
shown on the display:
Ï – high sensitivity, source far away
Î – low sensitivity, source very near
4
Press the record key, g, to confirm.
5
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
8.1.4 Monitoring during recording
Using this feature you can listen to the current recording using the
headphones (see also chapter 4.5.1 Connecting the headphones, page
16).
1
In stop mode (start-up screen), press MENU for at least two
seconds.
2
Press e to select the LI S T E N function.
3
Press h / b ON or OFF, to switch the feature on or o.
4
Press the record key, g, to confirm.
5
Press the j key to exit the menu.
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.

Philips VoiceTracer DVT1120 Specifications

General

Sample rate	12 kHz
Audio quality	- bit
Frequency range	750 - 18000 Hz
Product color	Gray
Compatible operating systems	Windows 10/8/7, macOS
Headphone outputs	1

Weight and Dimensions

Weight	46 g
Dimensions (WxDxH)	34 x 108 x 19 mm