15
Elevator Control
Aileron Control
10mm
10mm
Rudder Control
30mm
30mm
12mm
12mm
Ailerons : 10mm up 10mm down
Elevator : 10mm up 10mm down
Rudder : 30mm right 30mm left
CONTROL THROWS
1. We highly recommend setting up a plane using
the control throws listed.
2. The control throws should be measured at the
widest point of each control surface.
3. Check to be sure the control surfaces move in
the correct directions.
FLIGHT PREPARATION PRE FLIGHT CHECK
1. Completely charge your transmitter and receiver
batteries before your first day of flying.
2. Check every bolt and every glue joint in your
plane to ensure that everything is tight and well
bonded.
3. Double check the balance of the airplane
4. Check the control surface
5. Check the receiver antenna . It should be fully
extended and not coiled up inside the fuselage.
6. Properly balance the propeller.
To Next Page
Loading...
