6
20
9. Slide both wing to the fuselage, attach both
metal pushrod to the servo arm of the servo
retract gear.
Retract and the gear is opened.
Cowl
(head)
Retract and the gear is closed.
Cowl
(head)
21
2. Draw a center line onto the horizontal stabilizer
and slide it into the fuselage.
3. Check the fit of the horizontal stabilizer in its
slot. Make sure the horizontal stabilizer is
square and centered to the fuselage by taking
measurements, but don't glue anything yet.
INSTALLING THE HORIZONTAL STABILIZER
1. Using a modeling knife, cut away the covering
from the fuselage for the stabilizer and remove it.
To Next Page
Loading...
