Phonic ICON 700 - Specifications

10 ICON 300/700
Specifications
ICON 300 ICON 700
Direct Power Out
Max.average power at 45Hz-20kHz
With 0.1% THD
8 ohm 120W×2 240W×2
4 ohm 200W×2 400W×2
2 ohm,1kHz,1%THD 300W×2 550W×2
Bridged mono 8 ohm,1kHz,1%THD 420W 850W
Bridged mono 4 ohm,1kHz,1%THD 540W 1100W
Isolated Constant Voitage Out
200V or 140V Bridege 300W 700W
100V or 70V 150W×2 350W×2
25V 120W 280W×2
Frequency Response
Direct Outputs (+0/-2dB) 50Hz-50kHz
Isolated Outputs (+0/-2dB) 50Hz-16kHz
Total Harmonic Distortion
<0.05 <0.05
Sensitivity (fro full output) 1.02V 1.02V
Voitage Gain
28dB 32dB
Input Impedance
Balanced/Unbalanced 20k/10k ohm
Damping Factor >200(direct output)
S/N Ratio Less than 100dB below rated output (20Hz-20kHz)
Protection Circuits
● Output offset voitage protection
● Heat sink overheat protection
● Transformer overheat protection
● Load shorting protection
● Power on/off protection
Controls
Front Panel/ Power Switch/
Rear Panel
Ch1 & Ch2 gain controls (41 click); Parallel/Stereo/
Bridge switch
Connectors
Input/ XLR jack ×2,Barrier strip ×1/
Output Covered Barrier strip ×2;heavy-duty binding post
Cooling One dual speed fan
Indicators
Clip:Red Signal:Green
Protect:Yellow Power:
Red
Limit:Red Signal:Green
Protect:Yellow Power:
Red
Dimensions(H×W×D) 132×480×428mm 132×480×428mm
Net Weight
24.3KG 24.3KG
Shipping Weight
26.0KG 26.KG