Phonic PM 801 - Making Connections

6 PM 801
5� Prefader Output
This RCA output allows external devices to be
connected to the PM 801. Such devices may include
tape recorders, signal processors and other PM
801s.
6� +48V Phantom Power
These switches allow you to individually elect which
channel's microphone input jack to active phantom
power on. When activated, these switches provide
+48V of phantom power to the XLR connectors,
allowing condenser microphones to be used on these
channels. Before turning Phantom Power on, ensure
level controls are set to a minimum.
NB. Phantom Power should be used in conjunction with
balanced microphones. When Phantom Power is
engaged, single ended (unbalanced) microphones
and instruments should not be used on the Mic inputs.
Phantom Power will not cause damage to most dynamic
microphones, however if unsure, the microphone’s user
manual should be consulted.
7� Power Connector and Fuse Holder
This port is for the addition of a power cable and
supply, allowing power to be supplied to the mixer.
Please use the power cable that is included with this
mixer only. The Fuse holder, located above the AC
Power connector, is, of course, for the PM 801’s fuse.
If the fuse happens to blow, open the holder cover,
and replace the fuse with a suitable replacement (as
indicated on the fuse holder’s cover).
MAKING CONNECTIONS
1� XLR Jacks
These jacks accept XLR inputs for balanced signals.
They can be used in conjunction with microphones,
such as professional condenser, dynamic or ribbon
microphones - with standard XLR male connectors.
With low noise preampliers, these inputs serve for
crystal clear sound replication.
NB. When using an unbalanced microphone, please ensure
phantom power is switched off. However, when using
condenser microphones the phantom power should be
activated.
2� Line In Jacks
These inputs accept 1/4" TS line inputs for the addition
of various music instruments – such as keyboards,
drum machines, electric guitars, as well as a variety of
other line level instruments.
3� Aux Bus Input
This RCA input allows external devices to be
connected to the PM 801. Such devices may include
tape, CD players and other PM 801s.
4� Main Output
This 1/4" Phone Jack will output the nal line level
signal sent from the main mixing bus. The primary
purpose of this jack is to send the Main output to
external devices such as ampliers, active speakers,
as well as other, mixers, PA systems, and a wide
range of other possible signal processors.