12
Installation / Setup
3.6 Pairing & Programming Remote
Complete steps 2-5 in less than 8 seconds.
1. Press the ‘Programming button’ on the battery / receiver unit, this will send the awning down. Allow the awning to
travel 500mm from the top and press the ‘Programming button’ to stop at this position. This will stop the awning
from travelling beyond its top limit prior to the limits being set. Refer to Image 2 (page 4)
2. Press and hold the ‘Programming button’ on the battery / receiver unit
3. While still holding the ‘programming button’, select the channel on the remote control that you want the Awning to
operate on.
4. Now press and hold the ‘up’ button. The Awning will jog to indicate that it has paired with the remote control.
5. Release the ‘programming button’ on the battery pack /receiver
6. To operate the Awning, select the channel (make sure the green light is illuminated) and press the up/down button.
To remove a previous programmed channel, complete the same process as above; however press the DOWN button
instead of UP.
3.7 Change Motor Direction
If the Motor is mounted on the right-hand side, the motor direction will need to be changed to operate the Awning.
1. Select the channel that the Awning is paired with.
2. Press and hold the ‘ALL’ button for six seconds; the LED indicator L.E.D on the top of the remote will start flashing
green.
3. Point the remote at the ‘Programming IR’ located on the right-hand side of the battery pack / receiver unit. Press
and hold the ‘UP’ button on the remote; the Awning will jog to indicate the direction has been changed.
4. Press the ‘ALL’ button on the remote to save the motor direction.
To Next Page
Loading...