03_24
Headlight adjustment (03_24)
Proceed as follows:
1. Place the scooter in riding condition, unloaded, with the tyres correctly inflated, on
a flat piece of ground at a distance of 10 m from a white screen situated in a shaded
area, making sure that the scooter is perpendicular to the screen;
2. Draw a horizontal line on the screen at a height of 67 to 70 cm from the ground;
3. Switch on the headlight at low beam and check that the horizontal borderline of the
projected light beam between the dark and light area is not higher than the horizontal
line drawn on the screen;
4. If this is not the case, regulate the headlight by turning screw "A".
03_25
Rear optical unit (03_25, 03_26, 03_27, 03_28, 03_29)
To remove the rear light assembly, proceed as follows:
1. Remove the plastic cover "A" from the rear luggage rack, then remove the two lateral
screws of the lower part of the luggage rack proper.
2. Remove screw "B"
3. Remove screws "C" and the lateral panels of the side, paying attention not to dam-
age the retaining straps.
4. Remove the two screws "D" of the light assembly being tested and remove it.
You thus gain access to the rear light bulb "E", the stop light bulb "F" and turn indicator
bulbs "G".
Release the spring and take out the bulbs.
To replace the rear light bulbs "E", pull out the rubber lamp holder from its seat.
To reassemble, repeat the operation in the reverse order.
58
To Next Page
Loading...
