1.1 NORMATIVE DI RIFERIMENTO
DT2010027-02
1.11 Prevention of domestic fires
The product must be installed and used in compliance with the manufacturer’s instructions and European and national standards as well
as local regulations.
w
hen a flue pipe passes through a wall or a ceiling, special installation methods must be applied (protection, thermal insulation,
distances from heat-sensitive materials, etc.) See the paragraph “Connection to the flueway”
- It is also recommended that all elements made of combustible or inflammable material, such as beams, wooden furniture, curtaining, flam-
mable liquids, etc. be kept outside the heat radiation range of the stove and at a distance of at least 1m from the heating block.
-
For other information, see the paragraph “Minimum safety distances” and “Connection to the flueway”.
- The flue pipe, chimney stack, chimney and fresh air intake must always be free of obstructions, clean and checked periodically, that is, at
least twice during the seasonal period from the lighting of the stove and during its use. When the stove has not been used for some time
it is advisable to carry out the checks mentioned above. For further information, consult a chimneysweep.
- Only use recommended fuels (See paragraph “Fuel”).
H07020660 / DT2000245 - Rev. 03
34
English
To Next Page
Loading...
