PicoScope 3000A Series Prog rammer's Guide 121
Copyright © 2011-2013 Pico Technology Limited. All rights reserved. ps3000abpg.en r9
PICO_DATA_NOT_AVAILABLE
No data is available from a run block call
PICO_STRING_BUFFER_TOO_SMALL
The buffer passed for the information was too small
PICO_ETS_NOT_SUPPORTED
ETS is not supported on this device
PICO_AUTO_TRIGGER_TIME_TOO_SHORT
The auto trigger time is less than the time it will take to collect the pre-trigger
data
PICO_BUFFER_STALL
The collection of data has stalled as unread data would be overwritten
PICO_TOO_MANY_SAMPLES
Number of samples requested is more than available in the current memory
segment
PICO_TOO_MANY_SEGMENTS
Not possible to create number of segments requested
PICO_PULSE_WIDTH_QUALIFIER
A null pointer has been passed in the trigger function or one of the parameters
is out of range
PICO_DELAY
One or more of the hold-off parameters are out of range
PICO_SOURCE_DETAILS
One or more of the source details are incorrect
PICO_CONDITIONS
One or more of the conditions are incorrect
PICO_USER_CALLBACK
The driver's thread is currently in the ps3000a...Ready callback function and
therefore the action cannot be carried out
PICO_DEVICE_SAMPLING
An attempt is being made to get stored data while streaming. Either stop
streaming by calling ps3000aStop, or use ps3000aGetStreamingLatestValues
PICO_NO_SAMPLES_AVAILABLE
...because a run has not been completed
PICO_SEGMENT_OUT_OF_RANGE
The memory index is out of range
PICO_BUSY
Data cannot be returned yet
PICO_STARTINDEX_INVALID
The start time to get stored data is out of range
PICO_INVALID_INFO
The information number requested is not a valid number
PICO_INFO_UNAVAILABLE
The handle is invalid so no information is available about the device. Only
PICO_DRIVER_VERSION is available.
PICO_INVALID_SAMPLE_INTERVAL
The sample interval selected for streaming is out of range
PICO_MEMORY
Driver cannot allocate memory
PICO_SIG_GEN_PARAM
Incorrect parameter passed to the signal generator
PICO_SHOTS_SWEEPS_WARNING
Conflict between the shots and sweeps parameters sent to the signal
generator