PICO PicoScope 3204A Programmer's Guide

Prog ramming the 3000A Series oscilloscopes122
Copyright © 2011-2013 Pico Technology Limited. All rights reserved.ps3000abpg.en r9
33
PICO_WARNING_EXT_THRESHOLD_CONFLICT
Attempt to set different EXT input thresholds set for signal generator and
oscilloscope trigger
35
PICO_SIGGEN_OUTPUT_OVER_VOLTAGE
The combined peak to peak voltage and the analog offset voltage exceed the
allowable voltage the signal generator can produce
36
PICO_DELAY_NULL
NULL pointer passed as delay parameter
37
PICO_INVALID_BUFFER
The buffers for overview data have not been set while streaming
38
PICO_SIGGEN_OFFSET_VOLTAGE
The analog offset voltage is out of range
39
PICO_SIGGEN_PK_TO_PK
The analog peak to peak voltage is out of range
3A
PICO_CANCELLED
A block collection has been cancelled
3B
PICO_SEGMENT_NOT_USED
The segment index is not currently being used
3C
PICO_INVALID_CALL
The wrong GetValues function has been called for the collection mode in use
3F
PICO_NOT_USED
The function is not available
40
PICO_INVALID_SAMPLERATIO
The aggregation ratio requested is out of range
41
PICO_INVALID_STATE
Device is in an invalid state
42
PICO_NOT_ENOUGH_SEGMENTS
The number of segments allocated is fewer than the number of captures
requested
43
PICO_DRIVER_FUNCTION
You called a driver function while another driver function was still being
processed
PICO_RESERVED
45
PICO_INVALID_COUPLING
An invalid coupling type was specified in ps3000aSetChannel
46
PICO_BUFFERS_NOT_SET
An attempt was made to get data before a data buffer was defined
47
PICO_RATIO_MODE_NOT_SUPPORTED
The selected downsampling mode (used for data reduction) is not allowed
49
PICO_INVALID_TRIGGER_PROPERTY
An invalid parameter was passed to ps3000aSetTriggerChannelProperties
4A
PICO_INTERFACE_NOT_CONNECTED
The driver was unable to contact the oscilloscope
4D
PICO_SIGGEN_WAVEFORM_SETUP_FAILED
A problem occurred in ps3000aSetSigGenBuiltIn or ps3000aSetSigGenArbitrary
4E
PICO_FPGA_FAIL
4F
PICO_POWER_MANAGER
50
PICO_INVALID_ANALOGUE_OFFSET
An impossible analogue offset value was specified in ps3000aSetChannel
51
PICO_PLL_LOCK_FAILED
Unable to configure the PicoScope
52
PICO_ANALOG_BOARD
The oscilloscope's analog board is not detected, or is not connected to the
digital board

PICO PicoScope 3204A Specifications

General

Brand	PICO
Model	PicoScope 3204A
Category	Test Equipment
Language	English