Prog ramming the 3000A Series oscilloscopes124
Copyright © 2011-2013 Pico Technology Limited. All rights reserved.ps3000abpg.en r9
Data has been requested with ETS mode set but run block has not been
called, or stop has been called.
PICO_SIG_GEN_WHITENOISE_NOT_SUPPORTED
White noise is not supported on the opened device.
PICO_SIG_GEN_WAVETYPE_NOT_SUPPORTED
The wave type requested is not supported by the opened device.
PICO_INVALID_DIGITAL_PORT
A port number that does not evaluate to either PS3000A_DIGITAL_PORT0 or
PS3000A_DIGITAL_PORT1, the ports that are supported.
PICO_INVALID_DIGITAL_CHANNEL
The digital channel is not in the range PS3000A_DIGITAL_CHANNEL0 to
PS3000_DIGITAL_CHANNEL15, the digital channels that are supported.
PICO_INVALID_DIGITAL_TRIGGER_DIRECTION
The digital trigger direction is not a valid trigger direction and should be equal
in value to one of the PS3000A_DIGITAL_DIRECTION enumerations.
PICO_SIG_GEN_PRBS_NOT_SUPPORTED
Siggen does not generate pseudo-random bit stream.
PICO_ETS_NOT_AVAILABLE_WITH_LOGIC_CHANNELS
When a digital port is enabled, ETS sample mode is not available for use.
PICO_WARNING_REPEAT_VALUE
Not applicable to this device.
PICO_POWER_SUPPLY_CONNECTED
4-Channel only - The DC power supply is connected.
PICO_POWER_SUPPLY_NOT_CONNECTED
4-Channel only - The DC power supply isn’t connected.
PICO_POWER_SUPPLY_REQUEST_INVALID
Incorrect power mode passed for current power source.
PICO_POWER_SUPPLY_UNDERVOLTAGE
The supply voltage from the USB source is too low.
PICO_CAPTURING_DATA
The oscilloscope is in the process of capturing data.
PICO_USB3_0_DEVICE_NON_USB3_0_PORT
A USB 3.0 device is connected to a non-USB 3.0 port.
To Next Page
Loading...
Need help?
General
