Pima Captain 8 Installation Guide

Hunter-Pro Series Captain 8 - Installation Guide
26
4. Set the output's polarity ("P") to (-).
5. In the "Zone responses" menu, set the zone type/s to trigger the audio device when violated,
by setting parameter "M" to “+” see section 5.2, on page 48.
6. Set the control panel to play the voice massage instead of the alarm sound, when it calls the
end user: in the “Communication Options” menu, set “V – Voice unit” to “+” see section 6.4,
on page 51.
Single message wiring
1. Connect the Green wire (M1) to
the first output (including in
the zone expanders).
2. Connect the Yellow wire (M2)
to another output.
3. Connect the +/- wires to the
control panel's zones voltage.
4. Connect the Blue wire to the
control panel's AUDIO IN
terminal.
Diagram 26. VU-20U two message wiring
Two-message setting
To use the VU-20U for two messages, the panel must be set with two partitions: each partition will
trigger a different message see section 5.5, on page 48 for instructions.
To set the messages:
1. In the "Output configuration" menu, select the two outputs to which the VU-20U will be
connected to and triggered by see the programming diagram on section 0.
3
ENTR ENTRNEXT
X3
Communication
ENTER/NEXT/END
Commun. Options
ENTER/NEXT/END

PTLLTAVDRPOSD
+---+-+++-+--
ENTR END
AUDIO IN
Control panel
Blue
Red
Black
Green
Yellow
Audio
VU-20U
White
M1 M2 CONT +12V GND
C
O
N
T
I
N
O
U
T
A
U
D
I
O
A
G
N
D
Z7
Z8
-
+
Z O N E S
Z5
Z6
M1: to the first output
M2: to the second output

Pima Captain 8 Specifications

General

Brand	Pima
Model	Captain 8
Category	Security System
Language	English