Pioneer CDJ-200 User Manual (English)

Other manuals for Pioneer CDJ-200

Questions and Answers:

M
melaniephillipsAug 12, 2025
Why is there no sound coming from my Pioneer CD Player?
- A
  andreaaustinAug 12, 2025
  If no sound is coming from your Pioneer CD Player, first, double-check that all output cables are correctly connected and not loose, referring to the installation instructions. Also, verify the settings of your DJ mixer switches and sound volume controls. Ensure that pin plugs and amplifier terminals are clean. Finally, make sure the player isn't in pause mode by pressing the PLAY/PAUSE button.
K
Kevin GilbertAug 16, 2025
Why is my Pioneer CDJ-200 sound distorted and noisy?
- D
  Dr. Amanda ReedAug 16, 2025
  If the sound from your Pioneer CD Player is distorted or noisy, ensure that you're connected to the audio mixer's LINE INPUT terminals and not the MIC terminals. Clean any dirt from the pin plugs and amplifier terminals. Also, try switching off any nearby TV sets, moving the player away from them, or plugging the player into a separate outlet to avoid interference.
C
Curtis GuzmanAug 20, 2025
Why does my Pioneer CDJ-200 make loud noise or stop with some discs?
- M
  Mary MyersAug 20, 2025
  If your Pioneer CD Player produces loud noise or stops playing with certain discs, the disc might have a bad scratch or warp. Try replacing the disc. Alternatively, the disc might be extremely dirty, so try cleaning it.
D
Debra SmithAug 23, 2025
Why isn't track search finishing when auto cue is on with Pioneer CDJ-200?
- A
  Amanda DavisAug 25, 2025
  If the auto cue function is set ON and track search isn't finishing on your Pioneer CD Player, it may be because the muted portion between selections is too long. Press the AUTO CUE button to turn off the Auto Cue function.
Q
qconwayAug 27, 2025
Why doesn't the back cue function work on my Pioneer CDJ-200 CD Player?
- J
  Jonathon WilkinsAug 27, 2025
  If the back cue function cannot be carried out even though the CUE button is pressed in playback mode on your Pioneer CD Player, you may not have set the cue point yet. Also, if you are playing MP3s, back cue is only possible within the same folder.
J
Jack CooperAug 31, 2025
Why doesn't the OUT/OUT ADJUST button start loop play on my Pioneer CDJ-200?
- C
  Carlos JohnsonAug 31, 2025
  If pressing the OUT/OUT ADJUST button doesn't start loop play on your Pioneer CD Player, it's likely that no cue points (loop-in points) have been set. Set a cue point. Also, looping is only possible within the same track that has a cue point set when playing MP3s.
S
Stacy JonesSep 3, 2025
Why can't I search MP3s on my Pioneer CD Player?
- M
  marksmichaelSep 3, 2025
  If you cannot search MP3s on your Pioneer CD Player, it's because searching with MP3s is only possible within the same folder.
J
Jennifer LangSep 7, 2025
How to stop my Pioneer CDJ-200 from interfering with TV screen?
- J
  Jennifer VangSep 7, 2025
  If the TV screen picture fluctuates or FM broadcast is interfered with noise when using your Pioneer CD Player, turn off the POWER switch of the player, or move the player away from the TV or tuner.

Pioneer CDJ-200 Specifications

General

Frequency range	4 - 20000 Hz
Signal-to-Noise Ratio (SNR)	110 dB
Total Harmonic Distortion (THD)	0.006 %
CD-RW playback	Yes
Media types supported	CD, CD-R, CD-RW, MP3 CD
Device type	Portable CD player
Display type	-
Power requirements	220 - 240 V, 50/60 Hz
Power consumption (typical)	16 W
Dimensions (WxDxH)	216 x 292 x 99.5 mm