To Next PageTo Next PageWhy is the sound distorted or noisy on my Pioneer CDJ-500II?
Distorted sound or noise can occur due to several reasons. Ensure that the connections are correctly made to the audio mixer's LINE INPUT terminals, and not the MIC terminals. Clean any dirt from the pin plugs or amplifier terminals. Also, try switching off any nearby TV sets or moving the player away from them, as interference from the TV could be the cause.
Why Pioneer CDJ-500II CD Player track search is not finished?
If the track search on your Pioneer CD Player is not finishing when the auto cue function is ON, it may be because the muted portion between selections is too long. To resolve this, press the TIME MODE/AUTO CUE button for more than 1 second to set the auto cue function to OFF. Also, if the sound muted portion is recorded for about 20 seconds or more, playback will start without the auto cue function, so you should still set the auto cue function to OFF.
Why Pioneer CD Player disc is not rotating when the power is ON?
If the disc in your Pioneer CD Player is not rotating when the power is ON, it might be because the disc rotation stops automatically if no operation has been performed for 80 minutes or more in pause mode. You can start playback by pressing the PLAY/ PAUSE button, or open the door by pressing the EJECT button.
How to fix Pioneer CD Player when the door is not expelled?
If the door does not open when you press EJECT, check if the power plug is properly connected to the wall outlet. If it's disconnected, connect the plug to the outlet.
Why is my Pioneer CD Player disc not rotating when the power is on?
If the disc is not rotating, it might be because the disc rotation automatically stops if the CD player is in pause mode and no operation has been performed for 80 minutes or more. Press the PLAY/PAUSE button to start playback. Alternatively, pressing the EJECT button will open the door.
Why Pioneer CD Player has no sound?
If your Pioneer CD Player has no sound, there might be several reasons. Check if the output cables are connected properly. Verify the settings of your audio mixer, including switches and volume controls. Clean any dirt from the pin plugs or amplifier terminals. Also, ensure that the player is not in pause mode by pressing the PLAY/PAUSE button.
What does error code E-91 01 mean on my Pioneer CDJ-500II?
Error code E-91 01 indicates that there is a foreign object inside the disc compartment. Remove the object.
What does error code E-72 01 mean on my Pioneer CD Player and how to fix it?
Error code E-72 01 indicates that the disc is either dusty, dirty, or cracked. Try cleaning the disc first. If the problem persists, replace the disc.
What to do if my Pioneer CDJ-500II CD Player playback stops immediately or pauses?
If your CD Player stops or pauses during playback, ensure that the disc is loaded correctly, with the label side facing up. Additionally, check the disc for smudges and clean them before playing again.
How to fix fluctuated TV screen because of Pioneer CDJ-500II CD Player?
If the picture on your TV screen is fluctuating or FM broadcast is experiencing noise, it could be due to interference from the Pioneer CD player. Try turning off the power of the player or moving it away from the TV or tuner.
General| Playback Formats | CD, CD-R |
|---|---|
| Sampling Rate | 44.1 kHz |
| Bit Depth | 16-bit |
| Digital Output | No |
| Pitch Control | +/- 10% |
| Fader Start | Yes |
| Frequency Response | 4 Hz - 20 kHz |
| Total Harmonic Distortion | 0.006% |
| Outputs | RCA |
| Type | CD Player |
| Output Level | 2.0 V (at 0 dB) |
| Disc Type | 12 cm |
| Power Supply | AC 50/60 Hz |
