11
En
English
Installation and Connections
How to route cables
Speed clamps are included with this unit for bunching
cables together. Once components are connected, follow
the following steps to route cables.
Organize cables together using the provided speed
clamps.
Insert 1 into an appropriate hole on the rear of the unit,
then snap 2 into the back of 1 to fix the clamp.
Speed clamps are designed to be difficult to undo once in
place. Please attach carefully.
To attach the speed clamps to the main unit
Use the holes marked with the & sign as needed.
* As viewed from the rear of the display.
1
2
To remove speed clamps
Using pliers, twist the clamp 90° and pull it outward.
In some cases the clamp may have deteriorated over
time and may get damaged when removed.
* As viewed from the rear of the display.
Note
Cables can be routed to the right or left.
To Next Page
Loading...
