Pioneer PDP-503PU

3rd generation 50" PLASMA
Quick Reference Chart
PDP-503CMX PRO1000HDI PDP-503PU
PRO1000HD
(
1,2
)
AXY1053, 55 or 59
A
XY1059
(
1,2
)
AXY1053, 55 or 59
(
7
)
AXX1064
(
8541-35690
)
(
7
)
AXX1064, must chec
k
(
7
)
AXX1064
(
2431-12680
)
(7) must check
(3) New Scan IC S/N 9991 ALL 3051
(
2,3
)
AWU1068
A
WU1068
(
2,3,9
)
AWU1068
(8) AWU1110 (8) AWU1110 (8,9) AWU1110
(3) AWV1903 or 70,79
(9)AWV2029
Y Drive Assy (4) AWZ6645 or 6745 AWV6745 (4) AWZ6645, 6707 OR 46
X Drive Assy. (4) AWV1901 or 84 AWV1984 (4) AWV1901 or 84
(ADR)Resonance Assy (5, 6) AWZ6630, 91 or 6750 AWZ6750 (6) AWZ6691or 6750
Sub Address A Assy (5) AWZ6646 or 89 AWZ6689 AWZ6689
Sub Address B Assy (5) AWZ6647 or 90 AWZ6690 AWZ6690
V
Mid Clamp Ass
y
(1) AWV1934 N/A (1) AWV1934
AWZ6632
AWZ6744 (after # 10891)
I/O Assy AWZ6631 ' N/A
MR Interface Assy N/A N/A AWZ6699* (1621)
Audio Amp Assy N/A N/A AWZ6687
MX Audio Assy AWZ6644 ' N/A
FAN Moto
r
AXM1040 ' N/
A
SP Out R Ass
y
AWZ6636, 6706
A
WZ6706 N/
A
SP Out L Ass
y
AWZ6635, 6705
A
WZ6705 N/
A
(MX) LED Ass
y
AWZ6642 ' AWZ6655
Control Ass
y
AWZ6633 ' N/
A
IR Ass
y
AWZ6643 ' AWZ6658
(Side/Front) Key Ass
y
AWZ6637 ' AWZ6656
K
ey
C
onnec
t
or
A
ss
y
AWZ6638
,
6695
AWZ6695
AWZ6657
Thermal Sensor Ass
y
AWZ6639, 96
A
WZ6696 AWZ6660
V
ideo Card
AWV1906, 07**
A
WV2064 N/
A
Slot Connector Assy AWZ6634 ' N/A
Front Case Ass
y
AMB2698
A
MB2805 AMB2722
AC cord ADG1178, 1208
A
DG1208 ADG1178, 1208
Protect Panel Ass
y
AMR3266, 3304
A
MR3304 AMR3304
Display Stand
AMR3264, N/A
N/
A
PDK-TS01
Remote Control
AXD1459, 66
A
XD1459 RRMCG1679CES
A
System Cable (PDP-R03U) N/
A
N/
A
QCNW-6117CEZZ
Power Cord (PDP-R03U) N/
A
N/
A
QACCDA007WJP
Z
Service Manual
ARP3093/3101 & 3150
A
RP3150/87 ARP3107 & 3141
Owner's Manual ARD1042, 52/ARB1544 ARB1560 TINS-7552CEZZ
(1) See bulletin SI-D02012. Vmid moved to supply. If replacing AXY1053 with AXY1055 or 59, use exsisting Vmid.
(2) See bulletin SI-D03016A & 03026. AXY1059 replaces all, but must adjust if replacing old supply. Also adjust if panel replaced.
(3) See bulletin SI-D03025C. Use existing Dvid. Must use new with service panel. Scan Ics changed, SN755860PJ to SN755864APZP.
(4) See bulletin SI-D03041A. Use existing X or Y. If old to new must adjust.
(5) See bulletin SI-D03003. Use existing Addr. Reso & Sub Addr. If old to new, replace both.
(6) See bulletin SI-D03033. Improved caps and added insulator.
(7) See bulletin SI-D04048A, SI-PG04007. Mandatory upgrade (serial range where needed). Orange dot by serial #
indicates already done. AXX1064 is AXY1059-H. AXY1059-A thru G need replacing.
(8) See bulletin SP-D04014. Must adjust Vofs when using AWU1110.
(9) If 1st number of serial is 2, special panel used. If replacing panel, also replace digital video.
* See bulletin SI-D03004. Old part# was AWZ6654. Will need (2) screws PMZ26P080FZK for new board.
** Will need Torx Driver #T10H to remove.
ARP3162 has AWV1907 schematic.
Power Supply Module
Service Panel Assy
Digital Video Assy
(3) AWV1903 or 70,79 AWV2072
RGB Assy
AWZ6744 N/A
5