To Next PageTo Next Page
Need help?Do you have a question about the Pioneer PDP-503PU and is the answer not in the manual?
General| Screen Size | 50 inches |
|---|---|
| Display Type | Plasma |
| Aspect Ratio | 16:9 |
| Contrast Ratio | 3000:1 |
| Viewing Angle | 160 degrees |
| Resolution | 1280 x 768 |
| Input Ports | Component, Composite |
Details safety precautions, warnings, and notices for safe operation.
Safety warnings and procedures for leakage current tests.
Identifies charged sections and high voltage areas in the unit.
Explains symbols used in the manual for adjustments and services.
Details technical specifications and included accessories for the models.
Provides exploded views and parts list for packing.
Lists parts for the under layer sections of the unit.
Lists parts for the middle layer sections of the unit.
Lists parts for the upper layer sections of the unit.
Lists parts for Front Case, Rear, and Service Assy sections.
Provides overview and details of Assy block diagrams.
Displays waveform examples for Digital Video and other Assys.
Measurement conditions and cautions for the audio section.
Displays waveform examples for Sustain and Drive Pulse adjustments.
Lists components and part numbers for various PCB assemblies.
Instructions for operating the service factory mode.
Step-by-step guide on how to enter the service factory mode.
Displays general information about the plasma display and media receiver.
Details adjustment and setting items for the plasma display.
Lists adjustments needed after repairing or replacing specific assemblies.
Guides for adjusting VOFS, VH, and IC5V voltages.
Instructions for adjusting pulse waveforms, VRN voltage, and white balance.
Adjusting the timing of control signals for X and Y Drive Assys.
Procedures for measuring waveforms and performing coarse adjustments.
Adjusting SUS-D, SUS-U, and confirming waveforms.
Procedure for adjusting the SUS-B ground timing.
Details the RS-232C command connection and input timing.
Lists available RS-232C commands and their functions.
Describes GET commands for VR and White Balance adjustment data.
Provides diagnostic information and PCB layout.
Explains LED indicators for shut down and power down states.
Lists protection circuit functions and error diagnosis details.
Explains detect switch function and general disassembly steps.
Lists ICs and provides pin functions for various ICs.
Describes the panel facilities and controls of the plasma display.
