Pioneer PDP-505HD - Page 69

PDP-505HD
69
1 R-Y/R 6 666666––
2 R-Y/B 12 12 12 12 12 12 12 ––
3 G-Y/R 10 10 10 10 10 10 10 ––
4 G-Y/B 5 555555––
9 ENHANCER MAIN 0 000000––
10 ENHANCER V 0 000000––
Sharpness setting (Video signal input)
11 ENHANCER M 0 000000––
12 ENHANCER H 0 000000––
BS5 R-Y LEVEL –– –– –– –– –– –– ––
Color-difference adjustment
Adjustment required
BS7 B-Y LEVEL
(INPUT 1 only)
–– –– –– –– –– –– ––
BS9 Y DELAY Y delay setting (INPUT 1 only) 1 –– –– –– –– –– –– ––
BS11 CTI LEVEL Color transient setting (INPUT 1 only) 1 –– –– –– –– –– –– ––
1 CONTRAST Contrast adjustment
Adjustment required
2 BLACK LVL. Brightness adjustment
3 COLOR Color adjustment
Adjustment required
4 TINT Tint adjustment (C.Video signal input only)
H. SHARP Horizontal sharpness setting (Video signal input) 128 113 128 128 113 128 128 ––
5
H. ENHANCE Horizontal sharpness setting (PC signal input) –– –– –– –– –– –– –– 128
6 DETAIL Detail setting 123 123 128 128 123 128 128 128
7 R HIGH
8 G HIGH
9 B HIGH White Balance adjustment Adjustment required
10 R LOW
11 G LOW
12 B LOW
V. SHARP Vertical sharpness setting (Video signal input) 128 113 128 128 113 128 128 ––
BS5
V. ENHANCE Vertical sharpness setting (PC signal input) –– –– –– –– –– –– –– 128
BS9 ABL LEV OFFSET ABL Level offset adjustment
Adjustment required (note 2)
BS11 PLS NUM OFFSET Pulse number offset adjustment
REFERENCE 1 mode
REFERENCE 2 mode
Adjustment mode independent of input signal format / Data stored in EEPROM of ANALOG VIDEO ASSY
C. VIDEO/YC COMPONENT RGB VIDEO
NTSC STD × 2 HDTV STD × 2 HDTV
PC
C. VIDEO/YC COMPONENT RGB VIDEO
NTSC STD × 2 HDTV STD × 2 HDTV
PC
Remote
Control
Key
Adjustment
Parameter
Adjusting & Setting Item
Setting Value
Adjustment mode independent of input signal format / Data stored in EEPROM of UCOM ASSY
Remote
Control
Key
Adjustment
Parameter
Adjusting & Setting Item
Setting Value
Matrix demodulation angle setting
(Video signal input only)
Note 1) For Parameter , adjustment values are fixed.
Note 2) If unnecessarily adjusted, power consumption of the unit is changed and the panel is damaged.
Adjust only in case of necessity.