Using with other equipment
10
45
En
English
Connecting a personal computer
Use the PC terminals to connect a personal computer.
• The PC input terminal is DDC1/2B-compatible.
Displaying an image from a personal computer
To watch an image coming from the personal computer, press PC
on the remote control unit or press INPUT on the plasma television
to select “PC”.
When connecting to a personal computer, the correct input signal
type is automatically detected. If the personal computer image
does not come in clearly, you may need to use Auto Setup menu.
See page 37.
Note
• The PC terminals cannot be used for audiovisual equipment.
Computer compatibility chart
Connecting an amplifier/AV receiver
You can enjoy more powerful sound by connecting an amplifier/AV
receiver and subwoofer to the plasma television.
Note
• For details, refer to the operation manual for the audio
equipment to be connected.
• If your amplifier/AV receiver has a subwoofer output, it is not
necessary to connect the subwoofer output on the plasma
television.
• Audio signals corresponding to the currently displayed images
are always output to the MONITOR OUT and SUBWOOFER
terminals.
Avoiding unwanted feedback
You can prevent unwanted feedback from adversely affecting the
quality of images. Specify the output terminal whose output is to be
inhibited.
1 Press HOME MENU.
2 Select “Option“ (/ then ENTER).
3 Select “Monitor Out“ (/ then ENTER).
4 Select the desired parameter (/ then ENTER).
Resolution Frequency
720 x 400 70 Hz
640 x 480 (VGA) 60 Hz
800 x 600 (SVGA) 60 Hz
1280 x 720 60 Hz
1024 x 768 (XGA) 60 Hz
1360 x 768 (Wide-XGA) 60 Hz
1280 x 1024 (SXGA) 60 Hz
MONITOR
OUT
SUB
WOOFER
MONITOR
OUT
SUB
WOOFER
(Rear view)
Stereo
mini jack cable
RGB cable
Personal computer
(Rear view)
Subwoofer
AV receiver
MONITOR
OUT
SUB
WOOFER
MONITOR
OUT
SUB
WOOFER
Stereo audio cable Audio cable
Monitor Out
Always Output
INPUT 1 Prohibit
INPUT 2 Prohibit
INPUT 3 Prohibit
INPUT 4 Prohibit
INPUT 5 Prohibit
INPUT 6 Prohibit
To Next Page
Loading...
Need help?
General
