Pioneer PDP-R006FE - Adjustment; 6.1 Possible Cases Where Readjustment Is Required

PDP-R06XE
38
1234
1234
C
D
F
A
B
E
6. ADJUSTMENT
6.1 POSSIBLE CASES WHERE READJUSTMENT IS REQUIRED
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced.
Replacement of individual components on the circuitboard can cause malfunction and/or failure. If replacement is necessary, the
assembly must be replaced.
2. Use a stable AC power supply.
When any of the following assemblies is replaced
When any part in the following assemblies is replaced
POWER SUPPLY Unit No adjustment required
MR MAIN Assy No adjustment required
PC Card Module No adjustment required
R06 D-TUNER Assy No adjustment required
Other assemblies No adjustment required
POWER SUPPLY Unit
The assembly must be replaced as a unit, and no part
replacement is allowed.
Replacement of components IC4804, IC4806, IC5207,
IC6001, IC6003 and IC6201 on the circuitboard can cause
malfunction and/or failure. If replacement is necessary, the
assembly must be replaced.
The assembly must be replaced as a unit, and no part
replacement is allowed.
MR MAIN Assy
PC Card Module
The assembly must be replaced as a unit, and no part
replacement is allowed.
R06 D-TUNER Assy
Other assemblies No adjustment required