Pioneer PDP-R006FE - 6.5 List of RS-232 C Commands (Media Receiver)

PDP-R06XE
54
1234
1234
C
D
F
A
B
E
6.5 LIST OF RS-232C COMMANDS (MEDIA RECEIVER)
RS-232C commands can be used in Service Factory mode. Before using RS-232C commands, it is necessary to change the factory
presetting. See " 6.2 USING RS-232C COMANDS".
Refer to the service manual of the PDP506P/406P for the panel command.
[ Note : If you want to see version information (ex. QS1, QS6, Factory, Menu), Please see 10 seconds after starting. ]
Command Operation Remarks
B
BSL Adjust side mask B
C
CNG Clearing MR NG information
CHR Clearing MR Hour meter
D
DW* Decreasing the adjustment value by* *:1-9, 0(0 means 10),F(making the adjustment value the minimum)
F
FAN Turning Service Factory mode off.
FAY Turning Service Factory mode on.
FST Final Set Up
G
GSL Adjust side mask side mask G
I
INA Selection of tuner for terrestrial analog signals.
INC*** Selection of tuner for terrestrial digital signals
INH Selection of SD card/PCMCIA card
INPS01 Input selection: input 1
INPS02 Input selection: input 2
INPS03 Input selection: input 3
INPS04 Input selection: input 4
INPS05 Input selection: input 5
INPS06 Input selection: input 6 PDP-R06XE only
PDP-R06XE only
PDP-R06XE only
PDP-R06XE only
O
OSDS00 Turning the On-Screen Display off
Permit On-Screen Display.
OSDS01 Turning the On-Screen Display on
Prohibit On-Screen Display.
P
POF Turning the power off.
PON Turning the power on.
Q
QS1 Obtaining the version data for each device.
QS6 Obtaining the any version.
QMT Obtaining the MR temperature information.
QNG Obtaining NG data of the MR.
R
RSL Adjust side mask side mask R
U
UP* Increasing the adjustment value by * *:1-9, 0(0 means 10),F(making the adjustment value the maximum)
Z
ZME Initializing of the EEPROM video data