Piper SENECA II - Paragraph Grid no

PIPER SENECA II SERVICE MANUAL
10/31/19 V - TABLE OF CONTENTS
1F20C
5-1. Introduction ........................................................................................... 1F21
5-2. Description ............................................................................................ 1F21
5-2a. Flight Control Surface Travel ............................................................... 1F23
5-2b. Flight Control Cable Tension ............................................................... 1F23
5-3. Control Column Assembly ................................................................... 1F24
5-4. Removal of Control Column Assembly ......................................... 1F24
5-5. Installation of Control Column Assembly ..................................... 1F24
5-5a. Flex Joint Replacement Installation ............................................... 1G2B
5-6. Aileron Controls ................................................................................... 1G3
5-7. Removal of Aileron Control Cables ............................................... 1G3
5-8. Installation of Aileron Control Cables ........................................... 1G7
5-9. Removal of Aileron Bellcrank Assembly ...................................... 1G8
5-10. Installation of Aileron Bellcrank Assembly ................................... 1G8
5-11. Rigging and Adjustment of Aileron Controls ................................ 1G9
5-12. Stabilator Controls ................................................................................ 1G12
5-13. Removal of Stabilator Control Cables ........................................... 1G12
5-14. Installation of Stabilator Control Cables ........................................ 1G12
5-15. Rigging and Adjustment of Stabilator Controls ............................. 1G15
5-16. Stabilator Trim Controls ....................................................................... 1G17
5-17. Removal of Stabilator Trim Assembly (Forward) ......................... 1G17
5-18. Installation of Stabilator Trim Assembly (Forward) ...................... 1G18
5-19. Removal of Stabilator Trim Controls (Aft) .................................... 1G19
5-20. Installation of Stabilator Trim Controls (Aft) ................................ 1G20
5-21. Rigging and Adjustment of Stabilator Trim .................................. 1G20
5-22 Rudder Pedal Assembly ........................................................................ 1G21
5-23. Removal of Rudder Pedal Assembly ............................................. 1G21
5-24. Installation of Rudder Pedal Assembly .......................................... 1G22
5-25. Rudder Controls .................................................................................... 1G24
5-26. Removal of Rudder Control Cables ............................................... 1G24
5-27. Installation of Rudder Control Cables ............................................ 1G24
5-28. Rigging and Adjustment of Rudder Controls ................................. 1H2B
5-29. Rudder Trim Controls ........................................................................... 1H5
5-30. Removal of Rudder Trim Controls (Forward) ............................... 1H5
5-31. Installation of Rudder Trim Controls (Forward) ............................ 1H5
5-32. Removal of Rudder Trim Controls (Aft) ....................................... 1H6
5-33. Installation of Rudder Trim Controls (Aft) .................................... 1H6
5-34. Rigging and Adjustment of Rudder Trim Controls ........................ 1H7
SECTION V - SURFACE CONTROLS
TABLE OF CONTENTS
Paragraph Grid No.