4A-2
4A-3
4A-4
ø5mm
55mm
1/2 in.(13mm)
Socket Wrench
Position the wall plate at
your desired height and
line up the holes with your
stud center line. Level the
wall plate and mark the
holes.
Drill 4 pilot holes using a 5
mm diameter drill bit. Make
sure the depth is not less
than 55mm.
Install the wall plate [01]
or [01/02]. using lag bolts
[A] . Tighten the lag bolts
[A] only until they are
pulled firmly against the
wall plate.
6
A
To Next Page
Loading...
