1
＋
Before
Using
Features
Connecting
The Wires
Installing
The Product
Initial
Settings
How to
Operate
Speed Pulse
Settings
Trouble-
Shooting
Thank you for purchasing PIVOT product.
Please read this manual carefully and keep it for future
reference.
(BLP As of November, 2016 No.7)
Throttle Controller with Built-in MT Auto-Blipping Function
Product
If this product is given to another
user, make sure to include this
User’s Manual.
BLIPPING & THROCON
3
drive・BLP
Contents
Before Using …………………………………………………… 1
Product Features …………………………………………… 2–3
Features……………………………………………………… 2
Contents …………………………………………………… 2
Part Names / Display Items ……………………………… 3
WARNING / CAUTION ……………………………………… 3
procedure 1
Connecting The Wires ……………………… 4–6
Clutch Signal………………………………………………… 4
Brake Switch / Earth / Car Speed Signal …………… 5–6
procedure 2
Installing The Product ………………………… 6
procedure 3
Initial Settings (Degree of Acceleration Setting)…… 7
procedure 4
Speed Pulse Settings…………………………… 8
How to Operate………………………………………………8–10
Operating the Auto-Blipping …………………………… 8–9
Auto-Blipping Test…………………………………………… 9
Operating The Throttle Controller ………………………… 10
Basic Operation ……………………………………………… 11
Troubleshooting ………………………………………… 11–12
When uninstalling the product, make sure to return it to
nor
(NORMAL) Mode before carrying out any work.
Reconnecting this product in a different mode may cause the Check Engine Light to come on.
After installation, make sure to carry out “Initial Settings”.
Only use 3-drive Specialized Harness.
Worried about Installation?
After having installed this product, make sure to make settings for your car’s special characteristics by
carrying out the “Initial Settings” on Page 7. If the “Initial Settings” are not carried out, a Check Engine
Light may go on. Also, the unit will remain in NORMAL Mode even if the Mode is switched.
If you are worried about carrying out wiring or other installation procedures please consult your dealer.
Using another type of harness will cause troubles and failure; use only the 3-drive specialized harness.
Set to NORMAL Mode upon Removal of Product.
Under no circumstances should modifications or changes be made to this product. Doing so may cause damage
not only to the product, but to the car and the operation of the car in which it is installed.
Modifying this Product is Forbidden.
USER’S MANUAL
Product Number :
BLP
()
To Next Page
Need help?
General
