2 3
2 2
Shooting control
Shooting control
press button [ ], settings shot number can be reduced. It
can be set between 1 to 99 sheets .
3. Press button[ ]enter into the delay setting of delay
shooting. delay shooting time
icon[ ], delay shooting time value[ ]will blink at the
same time.
the delay shooting icon[ ] ,
4. Press the button[ ], set the delay time increased, press button[ ], set
the delay time reduced. It can be set between 1 to 59 seconds.
5. After set up the new parameters, press the set button, save and exit settings.
When enter to the delay shooting set, the transmitter will save the previous setting.
By pressing the left button[ ]or right button[ ], convert shooting numbers and delay
time settings.
Gently press button[ ]once to set numerical increased, hold it on, set the value rapidly
increased; Press the button[ ]once to set the numerical reduced, hold on to set the
values rapidly reduced.
Operate the delay shooting
1. Press the left button[ ]or right button[ ], move the transmitterās activity
icon to the delay shooting icon[ ].
2. Half-press the release button and transmitter will send
signal for focusing, the green indicator will lit on the
transmitter and receiver, and the camera is in the focusing
state until the release or full-press the button.
3. Full-press the release button, transmitter will send all
the delay shooting information to receiver, the transmitter
starts to delay countdown, and red indicator blink quickly
and enter to the delay shooting mode.
4. When countdown is completed, receiver will follow the
setting shots output a signal per second to control shooting.
When the camera function is set to be [ ], the camera will perform one or more delay
shooting.
When the camera lens focus function is set to be [ M ],the camera will not execute focusing
action if half-press the release button of the transmitter.
Make sure to set the camera function to be [ ].
When the camera function is set to be [ ], it will start continuous shooting.
When the camera function is set to be [ ],the camera will shoot based on [ ] function,
it may cause underexposure or overexposure.
To Next Page
Loading...
