Z-Meter DX4091/ User Guide PL Engineering Ltd
ver. 1.02 (2022) page 31 of 44
Set the required initial parameters for measurements in the
program window:
a) Set the geometric dimensions of the sample to be measured,
namely cross-section (a, b or dia. a) and height (h) in millimetres.
- You can set the dimensions using a built-in library of standard
dimensions.
Select actual dimensions (or close values) of testing samples from
the list and press button.
Selected dimensions will appear in Settings line.
- Or enter specific dimensions if they are not in the library, or if you
want more precision in dimension values.
To do this:
Select nearest dimensions from standard list as described above.
Open the list again.
And drop down to the end of the drop-down list.
To Next Page
Loading...