INSTALLATION
2
Installation Opening
To Install the Car Radio
This unit can be installed in any dashboard Having an
opening as shown the right figure.
If installation angle exceeds30 horizontal, the unit may
not perform properly.
1. Make sure the ignition is turned off, and then disconnect the cable from the vehicle
battery’s negative (-) terminal. You never want electricity running while you install this
double-DIN car receiver.
2. Before installation, remove the transport screws, disconnect the wire harness and the
antenna. Remove the detachable faceplate from the car receiver.
3. Attach the “L ” brackets (2pcs) on the both sides of the car receiver with screws(M5 x 8BM)
as shown as the below figure. The others fixing screws that fix the other terminal of the “L”
metal bracket, please buy from your dealer according to the drilling of holes size.
4. Consult with you nearest dealer if installation requires the drilling of holes or other modifi-
cations of the vehicle.
5.
6.
7. Install the detachable faceplate & plastic outer trim ring onto the car receiver.
8. Reconnect the battery and run through all of the options on this car receiver to ensure that
everything is working correctly.
Particulars will var
y widely depending upon the kind of your car and the car you intend to
install it in.
Always contact the car dealer or manufacturer if you have any questions.
Install the car receiver
in the dashboard.
Connect the wire harness & the antenna to the car receiver (see “Electrical Connections”)
being careful not to pinch any wires or cables.
9.
Please choose the correct installation method according to the actual situation
of your car.
Remove the transport
screws before installation.
7.2 inches
4.1 inches
To Next Page
Loading...
Need help?
General
