PLANET ECLIPSE ETHA2 - Velocity Adjustment

FIG-1
10
ETHA2 PAL
QUICK START
VELOCITY ADJUSTMENT
FIG-1
Insert a 1/8 hex key
A
into the velocity adjuster screw
B
to alter the
velocity of the ETHA2.
1
Turn the hex key clockwise to reduce velocity.
2
Turn the hex key counter-clockwise to increase velocity.
3
Fire two clearing shots after each velocity adjustment for an
accurate velocity reading.
1
DO NOT turn the adjuster screw in too far. This will prevent the
ETHA2 from ring.
–+
1
HEX
1/8
WARNING!
DO NOT exceed 300FPS.
ALWAYS wear correct protective equipment when ring your marker.
NEVER point your marker in the direction of other people when not on the eld.
ALWAYS be aware of where the barrel is facing when adjusting the velocity.
WARNING
A
B