PLANET ECLIPSE ETHA2 - Reset and Battery; Factory Reset Procedure

FIG-1
18
ETHA2 PAL
RESET
FACTORY RESET
It is important that the ETHA2 is set-up as per factory standards
before use. To restore to factory settings, follow these steps.
FIG-1
1
Enter set-up mode (see page 16). Reset all of the parameters to
their factory-set default values by pressing and holding the
tournament lock button for 2 seconds (see page 31). The status
indicator will ash BLUE when the parameters have been reset.
2
Using the 1/8 hex key
A
turn the inline regulator screw
B
4 turns
clockwise from it’s fully screwed-out position.
1
DO NOT turn the adjuster screw in too far. This will prevent the
ETHA2 from ring.
–+
1
HEX
1/8
A
B