BM-500 Bandwidth Management Gateway User’s Manual
- 12 -
Chapter 4: Web Configuration
4.1 System
The Bandwidth Management Gateway Administration and monitoring control is set by the System
Administrator. The System Administrator can add or modify System settings and monitoring mode. The sub
Administrators can only read System settings but not modify them. In System, the System Administrator can:
1. Add and change the sub Administrator’s names and passwords;
2. Back up all Bandwidth Management Gateway settings into local files;
3. Set up alerts for Hackers invasion.
“System” is the managing of settings such as the privileges of packets that pass through the Bandwidth
Management Gateway and monitoring controls. Administrators may manage, monitor, and configure
Bandwidth Management Gateway settings. All configurations are “read-only” for all users other than the
Administrator; those users are not able to change any settings for the Bandwidth Management Gateway.
Admin: has control of user access to the Bandwidth Management Gateway. He/she can add/remove users
and change passwords.
Setting: The Administrator may use this function to backup Bandwidth Management Gateway configurations
and export (save) them to an “Administrator” computer or anywhere on the network; or restore a
configuration file to the device; or restore the Bandwidth Management Gateway back to default factory
settings. Under Setting, the Administrator may enable e-mail alert notification. This will alert Administrator(s)
automatically whenever the Bandwidth Management Gateway has experienced unauthorized access or a
network hit (hacking or flooding). Once enabled, an IP address of a SMTP (Simple Mail Transfer protocol)
Server is required. Up to two e-mail addresses can be entered for the alert notifications.
Date/Time: This function enables the Bandwidth Management Gateway to be synchronized either with an
Internet Server time or with the client computer’s clock.
Language: Both Chinese and English are supported in the Bandwidth Management Gateway.
Multiple NAT Multiple NAT allows local port to set multiple subnet works and connect with the Internet
through different WAN IP Addresses.
Address: Enables the Administrator to authorize specific internal/external IP address(s for Management
Gateway.
Hack Alert When abnormal conditions occur, the Bandwidth Management Gateway will send an e-mail alert
to notify the Administrator, and also display warning messages in the Event window of Alarm.
Route Table Use this function to enable the Administrator to add static routes for the networks when the
dynamic route is not efficient enough.
DHCP Administrator can configure DHCP (Dynamic Host Configuration Protocol) settings for the LAN (LAN)
network.
Dynamic DNS The Dynamic DNS (require Dynamic DNS Service) allows you to alias a dynamic IP address
To Next Page
Loading...
