MB502 6” Deluxe Jointer
１５
5. Use only 3-wire extension cords that have grounding plugs, and the receptacles must
accept the tool’s plug.
6. Have a damaged or worn cord repaired or replaced immediately by a qualified
technician.
CONNECTING JOINTER TO POWER SOURCE
POWER CONNECTIONS
A separate electrical circuit should be used for your tools. Have a certified electrician
replace or repair a worn cord immediately. Before connecting the motor to a power line,
make sure the switch is in the “OFF” position and be sure that the electric current is of the
same characteristics as stamped on the motor nameplate. Running on low voltage will
damage the motor.
WARNING: DO NOT EXPOSE THE TOOL TO RAIN OR OPERATE THE TOOL IN
DAMP LOCATIONS.
GROUNDING INSTRUCTIONS
CAUTION: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE
OPERATOR FROM ELECTRIC SHOCK.
In the event of a malfunction or breakdown, grounding provides a path of least resistance
for electric current to reduce the risk of electric shock. This tool is equipped with an electric
cord having an equipment-grounding conductor and a grounding plug. The plug must be
plugged into a matching outlet that is properly installed and grounded in accordance with
all local codes and ordinances.
Do not modify the plug provided – if it will not fit the outlet; have the proper outlet installed
by a qualified electrician.
Improper connection of the equipment-grounding conductor can result in risk of electric
shock. The conductor with insulation having an outer surface that is green with or without
yellow stripes is the equipment-grounding conductor. If repair or replacement of the
electric cord or plug is necessary, do not connect the equipment-grounding conductor to a
live terminal.
Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the tool is properly grounded.
To Next Page
Loading...
Need help?
General