MB502 6” Deluxe Jointer
３
drugs, alcohol or any medication.
25. MAKE SURE TOOL IS DISCONNECTED FROM POWER SUPPLY while motor is
being mounted, connected or reconnected.
26. WARNING:
The dust generated by certain woods and wood products can be injurious
to your health. Always operate machinery in well-ventilated areas and provide for proper
dust removal. Use wood dust collection systems whenever possible.
ADDITIONAL SAFETY RULES FOR JOINTERS
1. WARNING: Do not operate the jointer until it is completely assembled and installed
according to the instructions.
2. IF YOU ARE NOT thoroughly familiar with the operation of jointers, obtain advice from
your supervisor, instructor or other qualified person.
3. KEEP cutterhead sharp and free of all rust and pitch.
4. BEFORE starting machine, check cutterhead guard to make sure it is not damaged and
operates freely.
5. ALWAYS make sure exposed cutterhead behind the fence is guarded, especially when
jointing near the edge.
6. NEVER perform jointing or planning operations with the cutterhead guard removed.
7. MAKE CERTAIN the infeed and outfeed tables are tightened before starting the
machine.
8. NEVER start the jointer with the workpiece contacting the cutterhead.
9. ALWAYS hold the workpiece firmly against the tables and fence.
10. NEVER perform any operation “Free-hand” which means using your hands to support
or guide the workpiece. ALWAYS use the fence to position and guide the work.
11. AVOID awkward operations and hand positions where a sudden slip could cause your
hand to move into the cutterhead.
12. ALWAYS use hold-down/push blocks for jointing material less than 3 inches in height
or planning material thinner than 3 inches.
To Next Page
Loading...
Need help?
General