SUBSCRIPTION
The headset and base unit are supplied subscribed to each other. However, if you wish to
use a replacement headset with the base unit then the units must be re-subscribed as
follows:
1. Return the headset to the headset charge cradle.
2. Press and hold both the talk volume fine tune buttons
on the base unit for a minimum of 5 seconds. The
power indicator 3 will then flash (red).
3. Press and hold the headset mute control button for
a minimum of 5 seconds. The talk indicator light 17
on the headset will then illuminate (green).
Successful re-subscription is indicated when the
power indicator is fully illuminated and the talk
indicator light is off.
4. To complete the process, reset the base unit by
disconnecting the AC power adapter 24 from the AC
power adapter jack 7 for 5 seconds, then reconnect.
5. If re-subscription fails within 2 minutes the headset
will return to the un-subscribed state. Try the re-
subscription process again or call Technical Support
(page 11).
SYSTEM RESET
To recover from some fault conditions, you may need to perform a system reset. Refer to
the Troubleshooting section on page 9.
To perform the system reset follow this procedure:
1. Press both the talk button 14 and the mute control 15 button on the headset
for 5 seconds.
2. When the talk indicator light 17 on the headset blinks, release both buttons.
3. Press the talk button again.
4. Next reset the base unit by disconnecting the AC power adapter 24 from the AC
power adapter jack 7 for 5 seconds, then reconnect.
The system reset operation is complete.
MAINTENANCE
1. Unplug the unit from the telephone and the AC adapter from the power source
before cleaning.
2. Clean the equipment with a damp (not wet) cloth.
3. Do not use solvents or other cleaning agents.
To Next Page
